Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE AND WHEEL SYSTEM

TIRE AND WHEEL SYSTEM > INSPECTION

for Preparation Click here



1. INSPECT TIRES
  1. Check the tires for wear and proper inflation pressure.

    Cold Tire Inflation Pressure:
    Tire Size
    Front Wheel
    kPa (kgf/cm2, psi)
    Rear Wheel
    kPa (kgf/cm2, psi)
    P265/70R17 113S
    220 (2.2, 32)
    220 (2.2, 32)
    265/70R17 115S
    220 (2.2, 32)
    220 (2.2, 32)



    R003031
  1. Using a dial indicator, check the tire runout.

    Tire runout:
    3.0 mm (0.118 in.) or less



2. ROTATE TIRES


C133111E02

HINT:
See the illustration on the left for how to rotate the tires, when you include the spare tire in the rotation.
Text in Illustration 
*a
Front of the Vehicle



3. INSPECT WHEEL BALANCE


C080976
  1. Perform off-car balancing.

  1. If necessary, perform on-car balancing.

    Imbalance after adjustment:
    Steel Wheel:
    12 g (0.026 lb) or less
    Aluminum Wheel:
    6 g (0.013 lb) or less



4. INSPECT FRONT AXLE HUB BEARING


F042746
  1. Inspect the axle hub backlash.

    1. Using a dial indicator, check the backlash near the center of the axle hub.

      Maximum:
      0.05 mm (0.0020 in.)

      If the backlash is greater than the maximum, replace the bearing.



    F042745
  1. Inspect the axle hub runout.

    1. Using a dial indicator, check the runout of the surface of the axle hub.

      Maximum:
      0.05 mm (0.0020 in.)

      If the runout is greater than the maximum, replace the bearing.



5. INSPECT REAR AXLE SHAFT BEARING


F042748
  1. Inspect the axle shaft backlash.

    1. Using a dial indicator, check the backlash near the center of the axle shaft.

      Maximum:
      0.05 mm (0.0020 in.)

      If the backlash is greater than the maximum, replace the bearing.



    F042747
  1. Inspect the axle shaft runout.

    1. Using a dial indicator, check the runout of the surface of the axle shaft.

      Maximum:
      0.05 mm (0.0020 in.)

      If the runout is greater than the maximum, replace the bearing.