Home › BRAKE › BRAKE › BRAKE PEDAL

BRAKE PEDAL > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with a painted surface.



3. REMOVE FRONT DOOR SCUFF PLATE

HINT:
Use the same procedure as for the RH side.



4. REMOVE FRONT FLOOR FOOTREST


    B130586
  1. Disengage the 4 claws and remove the front floor footrest.



5. REMOVE FOOTREST CLIP


    B130587
  1. Remove the 2 footrest clips.



6. REMOVE COWL SIDE TRIM BOARD

HINT:
Use the same procedure as for the RH side.



7. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP
  1. Separate the front door opening trim weatherstrip LH.



8. REMOVE INSTRUMENT PANEL NO. 1 REGISTER ASSEMBLY


    B133853
  1. Disengage the 4 clips and 2 claws and remove the instrument panel register.

    NOTICE:
    1. To avoid breakage of the register, remove the instrument panel register with the shut damper of the register open.
    2. Pull the instrument panel register up diagonally to remove it.



9. SEPARATE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B133859
  1. Disengage the 3 claws and separate the hood lock control lever.



10. REMOVE INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY


    B133860
  1. Remove the 2 <F> bolts.

  1. Disengage the 5 clips and claw and remove the lower instrument panel finish panel.

  1. Disconnect the connector.



11. REMOVE STOP LIGHT SWITCH
  1. Disconnect the stop light switch connector from the stop light switch.

  1. Turn the stop light switch counterclockwise and remove the stop light switch.



12. SEPARATE MASTER CYLINDER PUSH ROD CLEVIS


F050561
  1. Remove the clip and push rod pin and separate the push rod clevis.



13. REMOVE HYDRAULIC BRAKE BOOSTER


F051438E01
  1. Disconnect the 3 connectors from the hydraulic brake booster.



    C168977
  1. Using a union nut wrench, disconnect the 4 brake tubes from the hydraulic brake booster.



    C133114E01
  1. Use tags or labels to identify the place to reconnect each line.



    F050571
  1. Remove the 4 nuts and pull out the hydraulic brake booster.

  1. Remove the gasket from the hydraulic brake booster.



14. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY


C225098
  1. Remove the bolt and the brake pedal support.



15. REMOVE BRAKE PEDAL RETURN SPRING


F050564
  1. Remove the return spring from the brake pedal support and brake pedal.



16. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER
  1. Remove the stop light switch mounting adjuster from the brake pedal support.



17. REMOVE BRAKE PEDAL PAD
  1. Remove the brake pedal pad from the brake pedal.