FRONT BRAKE > INSTALLATION |
| 1. INSTALL FRONT DISC |
Align the matchmarks of the disc and axle hub and install the disc.
| 2. INSTALL DISC BRAKE CYLINDER ASSEMBLY |
![]() |
Install the disc brake cylinder with the 2 bolts.
![]() |
Using a union nut wrench, install the brake tube onto the disc brake cylinder.
| 3. INSTALL FRONT ANTI SQUEAL SHIM KIT |
![]() |
Apply disc brake grease to both sides of each No. 1 shim.
Install the No. 1 and No. 2 anti squeal shims onto each brake pad.
| 4. INSTALL FRONT DISC BRAKE PAD |
Install the 2 disc brake pads with anti squeal shims onto the disc brake cylinder.
| 5. INSTALL FRONT DISC BRAKE ANTI RATTLE WITH HOLE PIN |
![]() |
Install the anti rattle spring and 2 hole pins onto the disc brake cylinder.
Install the 2 new pin hold clips onto the hole pin.
| 6. BLEED BRAKE LINE |
Turn the ignition switch on (IG).
Remove the brake master cylinder reservoir filler cap assembly.
Add brake fluid until the fluid level is between the MIN and MAX lines of the reservoir.
Repeatedly depress the brake pedal and bleed air from the bleeder plug of the front disc brake cylinder RH.
Repeat the step above until the air is completely bled, and then tighten the bleeder plug while depressing the brake pedal.
Bleed the air from the bleeder plug of the front disc brake cylinder LH using the same procedure as for the RH side.
With the brake pedal depressed, loosen the bleeder plug of the rear disc brake cylinder RH, continue to hold the brake pedal and allow brake fluid to be drained from the bleeder plug while the pump motor operates.
When there is no more air in the brake fluid, tighten the bleeder plug, and then release the brake pedal.
Bleed the air from the bleeder plug of the rear disc brake cylinder LH using the same procedure as for the RH side.
Turn the ignition switch off (IG).
Inspect for brake fluid leaks.
Check and adjust the brake fluid level .
| 7. INSTALL FRONT WHEEL |