FRONT BRAKE > INSPECTION |
| 1. INSPECT BRAKE CYLINDER AND PISTON |
Check the cylinder bore and piston for rust and scoring.
If necessary, replace the disc brake cylinder and piston.
| 2. INSPECT PAD LINING THICKNESS |
![]() |
Using a ruler, measure the pad lining thickness.
| 3. INSPECT DISC THICKNESS |
![]() |
Using a micrometer, measure the disc thickness.
| 4. INSPECT DISC RUNOUT |
Check the bearing play in the axial direction and check for the axle hub runout .
![]() |
Provisionally fasten the front disc together with the hub nuts.
Using a dial indicator, measure the disc runout 10 mm (0.39 in.) away from the outer edge of the front disc.