Home › BRAKE › BRAKE › FRONT BRAKE

FRONT BRAKE > DISASSEMBLY

for Preparation Click here



1. REMOVE CYLINDER BOOT


F043024
  1. Using a screwdriver, remove the 4 set rings and 4 cylinder boots from the disc brake cylinder.



2. REMOVE FRONT DISC BRAKE PISTON


F042676E02
  1. Prepare a wooden plate to hold the pistons.



    F042677
  1. Place the plate between the pistons and insert a pad into one side.

  1. Apply compressed air to remove the pistons one side at a time from the disc brake cylinder.

    CAUTION:
    Do not place your fingers in front of the piston when applying compressed air.

    NOTICE:
    Do not spatter the brake fluid.



3. REMOVE PISTON SEAL


F042678
  1. Using a screwdriver, remove the 4 piston seals from the cylinder.

    NOTICE:
    Do not damage the inner surface or piston seal groove of the cylinder.



4. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP


5. REMOVE FRONT DISC BRAKE BLEEDER PLUG