Home › STEERING › POWER STEERING › VANE PUMP

VANE PUMP > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL RH


2. REMOVE FRONT FENDER APRON SEAL RH


    A223336
  1. Remove the 4 clips and front fender apron seal RH from the front fender apron sub-assembly RH.



3. REMOVE V-BANK COVER


    A229925E02
  1. Raise the front of the V-bank cover to disengage the 2 pins.
    Text in Illustration 
    *1
    Pin
    *2
    Hook
    *3
    No. 1 V-bank Cover Bracket

  1. Disengage the 2 hooks and remove the V-bank cover from the No. 1 V-bank cover bracket.



4. REMOVE FAN AND GENERATOR V BELT


    A217571
  1. While turning the V-ribbed belt tensioner assembly counterclockwise, align the service hole for the V-ribbed belt tensioner assembly and the V-ribbed belt tensioner assembly fixing position, and then insert a bar of φ 6 mm (0.236 in.) into the service hole to fix the V-ribbed belt tensioner assembly in place.

    HINT:
    The pulley bolt for the V-ribbed belt tensioner assembly has a left-hand thread.

  1. Remove the fan and generator V belt.



5. DRAIN POWER STEERING FLUID


6. SEPARATE PRESSURE FEED TUBE ASSEMBLY


    C217269
  1. Disconnect the oil pressure switch connector.

  1. Remove the bolt and the wire harness clamp bracket.



    C217267
  1. Remove the union bolt, then separate the pressure feed tube.

  1. Remove the gasket from the pressure feed tube.



7. SEPARATE NO. 1 OIL RESERVOIR TO PUMP HOSE


C217268
  1. Disengage the clip and separate the No. 1 oil reservoir to pump hose.



8. REMOVE VANE PUMP


    C217270
  1. Remove the 2 bolts and the vane pump.