Home › STEERING › POWER STEERING › VANE PUMP

VANE PUMP > DISASSEMBLY

for Preparation Click here



1. FIX VANE PUMP


C217271E01
  1. Using SST, fix the vane pump assembly in a vise.

    SST
    09630-00014   (09631-00132)

    NOTICE:
    Do not overtighten the vise.



2. REMOVE POWER STEERING SUCTION PORT UNION


    C217272
  1. Remove the bolt and suction port union.

  1. Remove the O-ring from the suction port union.



3. REMOVE PRESSURE FEED TUBE


    C217273
  1. Remove the bolt and pressure feed tube.

  1. Remove the 2 gaskets from the pressure feed tube.



4. REMOVE FLOW CONTROL VALVE


    C158958
  1. Remove the pressure port union.

  1. Remove the O-ring from the pressure port union.

  1. Remove the flow control valve and compression spring.



5. REMOVE VANE PUMP REAR HOUSING


    C131230
  1. Remove the 4 bolts and vane pump housing rear from the vane pump housing front.



    C107025E04
  1. Remove the O-ring from the vane pump housing front.
    Text in Illustration 
    *1
    Protective Tape



6. REMOVE PULLEY SHAFT SUB-ASSEMBLY

NOTICE:
Be careful not to drop or damage the pulley shaft. If damaged, replace it with a new one.



    C131231
  1. Using a screwdriver, remove the snap ring from the pulley shaft.

  1. Remove the pulley shaft.



7. REMOVE VANE PUMP ROTOR


    C114697
  1. Remove the 10 vane plates.

  1. Remove the vane pump rotor.



8. REMOVE VANE PUMP CAM RING


    C114698
  1. Remove the vane pump cam ring.



9. REMOVE VANE PUMP FRONT SIDE PLATE


C065368
  1. Remove the side plate from the vane pump housing front.

  1. Remove the O-ring from the side plate.



    F051267
  1. Remove the O-ring from the vane pump housing front.



10. REMOVE VANE PUMP HOUSING OIL SEAL


F051268
  1. Using screwdriver, remove the oil seal.

    NOTICE:
    Be careful not to damage the vane pump housing front.