Home › STEERING › POWER STEERING › VANE PUMP

VANE PUMP > INSPECTION

for Preparation Click here



1. INSPECT OIL CLEARANCE


F051269E05
Text in Illustration 
*1
Pulley Shaft
*2
Front Housing
*a
Bushing
  1. Using a micrometer and caliper gauge, measure the oil seal clearance.

    Standard clearance:
    0.021 to 0.043 mm (0.0008 to 0.0017 in.)

    Maximum clearance:
    0.07 mm (0.0028 in.)

    If it is greater than the maximum, replace the vane pump assembly.



2. INSPECT VANE PUMP ROTOR AND VANE PUMP PLATE


N000372E08
Text in Illustration 
*a
Thickness
*b
Height
*c
Length
  1. Using a micrometer, measure the height, thickness and length of the vane plates.

    Minimum height:
    7.6 mm (0.299 in.)

    Minimum thickness:
    1.405 mm (0.0553 in.)

    Minimum length:
    11.993 mm (0.4722 in.)



    R010282E18
  1. Using a feeler gauge, measure the clearance between a side face of the vane pump rotor groove and vane plate.
    Text in Illustration 
    *1
    Feeler Gauge

    Maximum clearance:
    0.025 mm (0.0010 in.)

    If it is greater than the maximum, replace the vane pump assembly.



3. INSPECT FLOW CONTROL VALVE


F051270
  1. Coat the flow control valve with power steering fluid and check that it falls smoothly into the flow control valve hole under its own weight.



    F052069E04
  1. Check the flow control valve for leakage. Close one of the holes and apply compressed air of 392 to 490 kPa (4 to 5 kgf/cm2, 57 to 71 psi) to the hole on the opposite side. Confirm that the air does not flow out from the end holes.
    Text in Illustration 
    *a
    Compressed Air
    If necessary, replace the flow control valve.



4. INSPECT COMPRESSION SPRING


R008702E16
Text in Illustration 
*1
Vernier Caliper
  1. Using a vernier caliper, measure the free length of the spring.

    Minimum free length:
    29.2 mm (1.150 in.)

    If it is not within the specification, replace the compression spring.



5. INSPECT PRESSURE PORT UNION SUB-ASSEMBLY
  1. If the union seat in the pressure port union is badly damaged, it could cause fluid leakage, so replace the vane pump assembly.