Home › TRANSMISSION ยท CLUTCH › CLUTCH MASTER CYLINDER

CLUTCH MASTER CYLINDER > REMOVAL

for Preparation Click here



1. DRAIN CLUTCH FLUID


2. DISCONNECT CLUTCH RESERVOIR TUBE


3. DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE


F050807
  1. Using a union nut wrench, disconnect the flexible hose tube.



4. REMOVE FRONT FLOOR FOOTREST


    B130586
  1. Disengage the 4 claws and remove the front floor footrest.



5. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure as for the RH side.



6. REMOVE COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure as for the RH side.



7. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


    B133853
  1. Disengage the 4 clips and 2 claws and remove the instrument panel register.

    NOTICE:
    1. To avoid breakage of the register, remove the instrument panel register with the shut damper of the register open.
    2. Pull the instrument panel register up diagonally to remove it.



8. REMOVE LOWER LH INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


    B133860
  1. Remove the 2 <F> bolts.

  1. Disengage the 5 clips and claw and remove the lower instrument panel finish panel.

  1. Disconnect the connector.



9. REMOVE INSTRUMENT PANEL LOWER LH


    B133864
  1. Remove the 4 <F> bolts and remove the lower instrument panel.



10. SEPARATE DRIVER SIDE JUNCTION BLOCK


    E129556
  1. Remove the 2 nuts and separate the main body ECU.



11. REMOVE CLUTCH PEDAL WITH CLUTCH MASTER CYLINDER
  1. Disconnect the clutch start switch connector.

  1. Disconnect the clutch switch connector. (w/ Cruise Control)



    C135779
  1. Remove the 2 nuts and bolt, then remove the clutch pedal with clutch master cylinder.



12. REMOVE CLUTCH MASTER CYLINDER ASSEMBLY
  1. Disconnect the clutch reservoir tube.



    C135771
  1. Using a union nut wrench, disconnect the 2 way tube from the clutch master cylinder.



    C133800
  1. Remove the nut and clutch start switch from the clutch pedal support.



    C135778
  1. Remove the clip and the pin and separate the push rod clevis from the clutch pedal.



    C135772
  1. Remove the 2 bolts, then remove the clutch master cylinder.