Home › TRANSMISSION ยท CLUTCH › CLUTCH PEDAL SWITCH

CLUTCH PEDAL SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL CLUTCH START SWITCH ASSEMBLY


F050806
  1. Install the clutch start switch assembly with the nut.

    Torque:
    16 N*m{ 160 kgf*cm , 12 ft.*lbf }

  1. Connect the clutch start switch assembly connector.



2. INSPECT CLUTCH START SWITCH ASSEMBLY


C135780
  1. Check that the engine does not start when the clutch pedal is released.

  1. Check that the engine starts when the clutch pedal is fully depressed.
    If necessary, replace the clutch start switch assembly.