Home › ENGINE › 1GR-FE ENGINE MECHANICAL › DRIVE BELT

DRIVE BELT > REMOVAL

for Preparation Click here



1. REMOVE FAN AND GENERATOR V BELT


    A217571
  1. While turning the V-ribbed belt tensioner assembly counterclockwise, align the service hole for the V-ribbed belt tensioner assembly and the V-ribbed belt tensioner assembly fixing position, and then insert a bar of φ 6 mm (0.236 in.) into the service hole to fix the V-ribbed belt tensioner assembly in place.

    HINT:
    The pulley bolt for the V-ribbed belt tensioner assembly has a left-hand thread.

  1. Remove the fan and generator V belt.