CLUTCH PEDAL > ON-VEHICLE INSPECTION |
| 1. INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY |
Pull back the floor carpet.
![]() |
Check that the pedal height is correct.
Adjust the pedal height. (w/ Cruise Control)
Loosen the lock nut and turn the clutch switch until the height is correct. Tighten the lock nut.
Adjust the pedal height. (w/o Cruise Control)
Loosen the lock nut and turn the stopper bolt until the height is correct. Tighten the lock nut.
Check that the pedal free play and push rod play are correct.
Depress the pedal until the clutch resistance begins to be felt.
Gently depress the pedal until the resistance begins to increase a little.
![]() |
Adjust the pedal free play and push rod play.
Loosen the lock nut and turn the push rod until the free play and push rod play are correct.
Tighten the lock nut.
After adjusting the pedal free play, check the pedal height.
Connect the air duct and install the lower finish panel.
![]() |
Check the clutch release point.
Pull the parking brake lever and chock the wheels.
Start the engine and allow it to idle.
Without depressing the clutch pedal, slowly move the shift lever into the reverse position until the gears engage.
Gradually depress the clutch pedal and measure the stroke distance from the point that the gear noise stops (release point) up to the full stroke end position.