Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK MAIN BODY ECU

B136051E12


B136052E07

  1. Disconnect the 1A, 1B, 1E and 1H main body ECU connectors.

  2. Measure the voltages and resistances of the wire harness side connectors.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    1A-7 (GND2) - Body ground
    W - Body ground
    Ground
    Always
    Below 1 Ω
    1B-4 (BECU) - Body ground
    W-R - Body ground
    Power source circuit (from battery)
    Always
    11 to 14 V
    1E-9 (BDR1) - Body ground
    B-Y - Body ground
    Power source circuit (from battery)
    Always
    11 to 14 V
    1H-2 (GND1) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω

  3. Reconnect the main body ECU connectors.

  4. Measure the voltages of the wire harness side connectors.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    1A-8 (ILE) - Body ground
    W - Body ground
    Illumination signal (to room light assembly)
    Driver door closed
    11 to 14 V
    Driver door open
    Below 1 V
    1B-3 (H-ON) - Body ground
    GR-G - Body ground
    DRL signal (to DRL relay)
    Light control switch off or in TAIL and engine running and parking brake off
    Below 1 V
    Ignition switch off
    11 to 14 V
    1B-8 (HRLY) - Body ground
    Y-P - Body ground
    HEAD signal (to HEAD relay)
    Light control switch off or in TAIL
    11 to 14 V
    Light control switch in HEAD
    Below 1 V
    1B-9 (TRLY) - Body ground
    G - Body ground
    TAIL signal (to TAIL relay)
    Light control switch off
    11 to 14 V
    Light control switch in TAIL or HEAD
    Below 1 V
    1B-11 (TRLY) - Body ground
    G - Body ground
    TAIL signal (to TAIL relay)
    Light control switch off
    11 to 14 V
    Light control switch in TAIL or HEAD
    Below 1 V
    1D-5 (ACC) - Body ground
    W-G - Body ground
    Ignition switch ACC signal circuit (to ignition switch)
    Ignition switch off
    Below 1 V
    Ignition switch ACC
    11 to 14 V
    1F-8 (SIG) - Body ground
    B-R - Body ground
    Ignition switch signal
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V
    1F-13 (TRLY) - Body ground
    G - Body ground
    TAIL signal (to TAIL relay)
    Light control switch off
    11 to 14 V
    Light control switch in TAIL or HEAD
    Below 1 V
    1K-9 (ILE) - Body ground
    R-W - Body ground
    Illumination signal (to room light assembly)
    Driver door closed
    11 to 14 V
    Driver door open
    Below 1 V
    1L-5 (TRLY) - Body ground
    G - Body ground
    TAIL signal (to TAIL relay)
    Light control switch off
    11 to 14 V
    Light control switch in TAIL or HEAD
    Below 1 V
    E6-3 (LMRY) - Body ground
    GR-R - Body ground
    DOME relay output signal (to DOME relay)
    DOME relay on
    Below 1 V
    DOME relay off
    11 to 14 V
    E6-7 (DIM) - Body ground
    R-G - Body ground
    DIM relay output signal (to DIM relay)
    Dimmer switch in FLASH or HIGH
    Below 1 V
    Dimmer switch in LOW
    11 to 14 V
    E6-14 (L) - Body ground
    GR - Body ground
    Generator operate condition signal
    Engine start charge warning light ON
    Below 1 V
    Engine start charge warning light OFF
    11 to 14 V
    E7-2 (PKB) - Body ground
    W-R - Body ground
    Parking brake switch signal
    Parking brake switch ON
    Below 1 V
    Parking brake switch OFF
    11 to 14 V
    E7-7 (BCTY) - Body ground
    W - Body ground
    Back door courtesy switch input
    Back door open
    Below 1 V
    Back door closed
    9 to 14 V (or pulse generation)
    E7-11 (RLCY) - Body ground
    P-B - Body ground
    Rear LH door courtesy switch input
    Rear LH door open
    Below 1 V
    Rear LH door closed
    9 to 14 V (or pulse generation)
    E7-12 (RRCY) - Body ground
    P-L - Body ground
    Rear RH door courtesy switch input
    Rear RH door open
    Below 1 V
    Rear RH door closed
    9 to 14 V (or pulse generation)
    E7-23 (DCTY) - Body ground
    R-B - Body ground
    Driver door courtesy switch input
    Driver door open
    Below 1 V
    Driver door closed
    9 to 14 V (or pulse generation)
    E7-24 (PCTY) - Body ground
    R-B - Body ground
    Front passenger door courtesy switch input
    Front passenger door open
    Below 1 V
    Front passenger door closed
    9 to 14 V (or pulse generation)
    E8-1 (HEAD) - Body ground
    R - Body ground
    Light control switch (HEAD signal)
    Ignition switch ON, light control switch off
    11 to 14 V
    Ignition switch off, light control switch off
    9 to 14 V (or pulse generation)
    Light control switch ON
    Below 1 V
    E8-2 (HU) - Body ground
    R-G - Body ground
    Headlight dimmer switch (HIGH signal)
    Headlight dimmer switch in HIGH
    Below 1 V
    Headlight dimmer switch in LOW
    11 to 14 V
    E8-7 (HF) - Body ground
    R-W - Body ground
    Headlight dimmer switch (FLASH signal)
    Headlight dimmer switch in FLASH
    Below 1 V
    Headlight dimmer switch in LOW or HIGH
    11 to 14 V
    E8-8 (TAIL) - Body ground
    G - Body ground
    Light control switch (TAIL signal)
    Ignition switch ON, light control switch off
    11 to 14 V
    Ignition switch off, light control switch off
    9 to 14 V (or pulse generation)
    Light control switch in TAIL
    Below 1 V
    E8-3 (A) - Body ground*1
    L - Body ground
    Light control switch (DRL signal)
    Ignition switch ON, light control switch off
    11 to 14 V
    Ignition switch off, light control switch off
    9 to 14 V (or pulse generation)
    Light control switch in DRL
    Below 1 V
    E8-20 (HF2) - Body ground
    Y-P - Body ground
    Headlight dimmer switch (FLASH signal)
    Headlight dimmer switch in FLASH
    Below 1 V
    Headlight dimmer switch in LOW or HIGH
    11 to 14 V

    1. *1: w/ DRL OFF function