Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK MAIN BODY ECU

B136051E05


B136052E05

  1. Disconnect the 1A, 1B, 1E, and 1H main body ECU connectors.

  2. Measure the voltages and resistances of the wire harness side connectors.

    Standard: 
    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    1H-2 (GND1) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    1B-4 (BECU) - Body ground
    W-R - Body ground
    Power source circuit (From battery)
    Always
    11 to 14 V
    1E-9 (BDR1) - Body ground
    B-Y - Body ground
    Power source circuit (From battery)
    Always
    11 to 14 V
    If the result is not as specified, there may be a malfunction in the wire harness.

  3. Reconnect the main body ECU connectors.

  4. Measure the voltages of the wire harness side connectors.

    Standard voltage: 
    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    1F-8 (SIG) - Body ground
    B-R - Body ground
    Ignition switch signal
    Ignition switch is OFF
    Below 1V
    Ignition switch is ON
    11 to 14 V
    1L-9 (ACT+) - Body ground
    L-R - Body ground
    Driver side door lock motor LOCK drive output
    Door control switch or Door key cylinder OFF
    Below 1V
    Door control switch or driver side door key cylinder ON (LOCK)
    11 to 14 V → Below 1 V
    1L-6 (ACT+) - Body ground
    L-R - Body ground
    Passenger side door lock motor LOCK drive output
    Door control switch or Door key cylinder OFF
    Below 1V
    Door control switch or driver side door key cylinder ON (LOCK)
    11 to 14 V → Below 1 V
    E6-10 (ACTD) - Body ground
    L-B - Body ground
    Driver side door lock motor UNLOCK drive output
    Door control switch or Door key cylinder OFF
    Below 1V
    Door control switch or driver side door key cylinder ON (UNLOCK)
    11 to 14 V → Below 1 V
    1L-18 (ACT-) - Body ground
    L-B - Body ground
    Passenger side door lock motor UNLOCK drive output
    Door control switch or Door key cylinder OFF
    Below 1V
    Door control switch or driver side door key cylinder ON (UNLOCK)
    11 to 14 V → Below 1 V
    E6-21 (LSWD) - Body ground
    W-R - Body ground
    Driver side door unlock detection switch input
    Driver side door unlocked
    Below 1V
    Driver side door locked
    11 to 14 V
    E6-30 (LSWP) - Body ground
    B-W - Body ground
    Passenger side door unlock detection switch input
    Passenger side door unlocked
    Below 1V
    Passenger side door locked
    11 to 14 V
    1F-4 (LSR) - Body ground
    B - Body ground
    Back door unlock detection switch input
    Back door unlocked
    Below 1V
    Back door locked
    11 to 14 V
    1K-3 (L2) - Body ground
    L - Body ground
    Driver side and passenger side door key-linked operated door lock switch input
    Driver side and passenger side door key cylinder OFF
    11 to 14 V
    Driver side or passenger side door key cylinder ON (LOCK)
    Below 1 V
    E6-12 (UL3) - Body ground
    P - Body ground
    Driver side door key-linked operated door unlock switch input
    Driver side door key cylinder OFF
    11 to 14 V
    Driver side door key cylinder ON (UNLOCK)
    Below 1 V
    E6-22 (UL2) - Body ground
    Y-G - Body ground
    Passenger side door key-linked operated door unlock switch input
    Passenger side door key cylinder OFF
    11 to 14 V
    Passenger side door key cylinder ON (UNLOCK)
    Below 1 V
    E7-7 (BCTY) - Body ground
    W - Body ground
    Back door courtesy switch and back window courtesy switch input
    Back door or back window open
    Below 1V
    Back door and back window closed
    11 to 14 V
    E7-11 (RLCY) - Body ground
    P-B - Body ground
    Rear LH door courtesy switch input
    Rear LH door open
    Below 1V
    Rear LH door closed
    11 to 14 V
    E7-12 (RRCY) - Body ground
    P-L - Body ground
    Rear RH door courtesy switch input
    Rear RH door open
    Below 1V
    Rear RH door closed
    11 to 14 V
    E7-23 (DCTY) - Body ground
    R-B - Body ground
    Driver door courtesy switch input
    Driver door open
    Below 1V
    Driver door closed
    11 to 14 V
    E7-24 (PCTY) - Body ground
    R-B - Body ground
    Front passenger door courtesy switch input
    Front passenger door open
    Below 1V
    Front passenger door closed
    11 to 14 V
    E8-14 (KSW) - Body ground
    G-Y - Body ground
    Key unlock warning switch input
    Key inserted in ignition key cylinder
    Below 1V
    Key removed from ignition key cylinder
    11 to 14 V
    E6-23 (MPX2) - Body ground
    BR-R - Body ground
    Multiplex communication signal
    During communication
    Signal waveform
    If the result is not as specified, there may be a malfunction in the wire harness.


CHECK BACK DOOR ECU

B062706E02

  1. Disconnect the S2 back door ECU connector.

  2. Measure the voltages and resistances of the wire harness side connectors.

    Standard: 
    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    S2-5 (BECU) - Body ground
    W-R - Body ground
    Power source circuit (From battery)
    Always
    11 to 14 V
    S2-3 (GND) - Body ground)
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction in the wire harness.

  3. Reconnect the back door ECU connector.

  4. Measure the voltages of the wire harness side connectors.

    Standard voltage: 
    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    S2-6 (SIG) - Body ground
    B-R - Body ground
    Ignition switch signal
    Ignition switch OFF
    Below 1V
    Ignition switch ON
    11 to 14 V
    S5-5 (L) - Body ground
    L - Body ground
    Back door key-linked operated door lock switch input
    Back door key cylinder OFF
    11 to 14 V
    Back door key cylinder ON (LOCK)
    Below 1 V
    S5-4 (UL) - Body ground
    R - Body ground
    Back door key-linked operated door unlock switch input
    Driver side door key cylinder OFF
    11 to 14 V
    Driver side door key cylinder ON (UNLOCK)
    Below 1 V
    S2-1 (MPX2) - Body ground
    BR-R - Body ground
    Multiplex communication signal
    During communication
    Signal waveform
    S5-15 (ACT+) - Body ground
    G - Body ground
    Back door lock motor LOCK drive output
    Door control switch or Door key cylinder OFF
    Below 1V
    Door control switch or driver side door key cylinder ON (LOCK)
    11 to 14 V → Below 1 V
    S5-14 (ACT-) - Body ground
    W - Body ground
    Back door lock motor UNLOCK drive output
    Door control switch or Door key cylinder OFF
    Below 1V
    Door control switch or driver side door key cylinder ON (UNLOCK)
    11 to 14 V → Below 1 V
    If the result is not as specified, there may be a malfunction in the wire harness.