Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > Headlight Relay Circuit

for Preparation Click here


DESCRIPTION

The headlight dimmer switch sends a signal to the main body ECU.

WIRING DIAGRAM


E260205E01


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM (HEAD LIGHT)
  1. Connect the Techstream to DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Main Body / Active Test.

  1. Check the headlight (Low-beam) while operating the headlight relay using the Techstream.

    Main Body ECU 
    Tester Display
    Test Part
    Control Range
    Normal Condition
    Headlight Relay
    Headlight Relay
    OFF/ON
    -

    OK:
    The headlight (low-beam) comes on when operating it through the Techstream.



OK
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
NG


2.INSPECT HEADLIGHT RELAY


    E109076E03
  1. Remove the HEAD relay from the No. 2 engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Apply the battery voltage between terminals 1 and 2
    Below 1 Ω

  1. Reinstall the HEAD relay.



NG
REPLACE HEADLIGHT RELAY
OK


3.CHECK HARNESS AND CONNECTOR (BATTERY - HEADLIGHT RELAY)
B136078E02
  1. Remove the HEAD relay from the No. 2 engine room relay block.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester connection
    Condition
    Specified Condition
    HEAD relay terminal 1 - Body ground
    Always
    11 to 14 V
    HEAD relay terminal 5 - Body ground
    Always
    11 to 14 V

  1. Reinstall the HEAD relay.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (HEADLIGHT RELAY - MAIN BODY ECU)


    B136079E02
  1. Remove the HEAD relay from the No.2 engine room relay block.

  1. Disconnect the main body ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified Condition
    HEAD relay terminal 2 - 1B-8 (HRLY)
    Always
    Below 1 Ω
    HEAD relay terminal 2 or 1B-8 (HRLY) - Body ground
    Always
    10 kΩ or higher

  1. Reinstall the HEAD relay.

  1. Reconnect the main body ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)