Home › MAINTENANCE › MAINTENANCE › CHASSIS

CHASSIS > GENERAL MAINTENANCE



1. INSPECT STEERING LINKAGE
  1. Check the steering linkage for looseness or damage.

    1. Check that the tie rod ends do not have excessive play.

    2. Check that the dust seals and boots are not damaged.

    3. Check that the boot clamps are not loose.

  1. Inspect the dust cover for damage.



2. INSPECT STEERING GEAR HOUSING OIL
  1. Check the steering gear housing for oil leakage.
    If leakage is found, check for the cause and repair it.



3. INSPECT BALL JOINT AND DUST COVER
  1. Jack up the front of the vehicle and support it with stands.

  1. Make sure the front wheels are in a straight-ahead position, and depress the brake pedal.

  1. Jack up the lower suspension arm until there is about half a load on the front suspension.

  1. Inspect the dust cover for damage.



4. INSPECT DRIVE SHAFT BOOTS (for 4WD)
  1. Inspect the drive shaft boots for clamp looseness, grease leakage or damage.



5. INSPECT TRANSFER OIL (for 4WD)
  1. Remove the filler plug and feel inside the hole with your finger. Check that the oil comes to within 5 mm (0.20 in.) of the bottom edge of the hole. If the level is low, add oil until it begins to run out of the filler hole.



6. INSPECT DIFFERENTIAL OIL


    D025304E05
  1. Remove the filler plug and feel inside the hole with your finger. Check that the oil comes to within 5 mm (0.20 in.) of the bottom edge of the hole. If the level is low, add oil until it begins to run out of the filler hole.



7. REPLACE AUTOMATIC TRANSMISSION FLUID LEVEL
  1. Check the level of the automatic transmission fluid.
    Type
    See Procedure
    A750E
    Click here
    A750F
    Click here



8. LUBRICATE PROPELLER SHAFT AND TIGHTEN BOLTS


  1. 4WD:



    1. Lubricate propeller shaft, referring to the lubrication chart. Before pumping in grease, wipe off any mud and dust on the grease fitting.

      Grease grade:
      Spider:
      Lithium base chassis grease (NLGI No.2)
      Slide yoke and double-cardan joint:
      Molybdenum diaulphide lithium base chassis grease (NLGI No.2)



      B065528E01

  1. Tighten the bolts of the propeller shaft.
    Type
    See Procedure
    Front propeller shaft
    Click here
    Rear propeller shaft (for 2WD)
    Click here
    Rear propeller shaft (for 4WD)
    Click here



9. INSPECT MANUAL TRANSMISSION OIL


D025304E01
  1. Park the vehicle in a level place.

  1. Remove the transmission filler plug and gasket.

  1. Check that the oil surface is within 5 mm (0.20 in.) of the lowest point of the transmission filler plug opening.

    Manual Transmission Oil:
    Oil Grade:
    API GL-4
    Viscosity:
    SAE 75W-90
    Standard Capacity:
    1.8 Liters (1.9 US qts, 1.6 Imp. qts)

    NOTICE:
    1. Problems may occur when the oil level is too high or low.
    2. After replacing the oil, drive the vehicle and check the oil level again.

  1. Check for oil leakage when the oil level is low.

  1. Install the transmission filler plug and a new gasket.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }