Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

The DLC3 circuit enables reading of Diagnostic Trouble Codes (DTCs) without using Techstream by connecting terminals TC and CG of the DLC3 connector.
Stored DTCs are displayed in blinking patterns of the CRUISE MAIN indicator light located on the combination meter.

WIRING DIAGRAM


B133357E01

HINT:
When a particular warning light blinks continuously, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in the relevant ECU is suspected.


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TC of DLC3 - ECM)
  1. Disconnect the E77 connector of the ECM.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    TC (E1-13) - TC (E77-28)
    Below 1 Ω

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (TC of DLC3 - ECM)
OK


2.CHECK HARNESS AND CONNECTOR (TC of DLC3 - BODY GROUND)


    E130793E01
  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    TC (E1-13) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (TC CIRCUIT)
OK


3.CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)


    E130793E04
  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    CG (E1-4) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (CG of DLC3 - BODY GROUND)
OK

REPLACE ECM