Home › BODY › ENGINE HOOD / DOOR › BACK WINDOW SUPPORT

BACK WINDOW SUPPORT > DISPOSAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. DISPOSE OF BACK WINDOW SUPPORT


B135552E01
  1. Horizontally fix the back window support in a vise with the piston-rod pulled out.

  1. Wearing protective glasses, using a metal saw gradually cut the shaded part between A and B, shown in the illustration, to gradually release the gas.

    Specification:
    Area
    Measurement
    a
    80 mm (3.15 in.)
    b
    20 mm (0.80 in.)

    CAUTION:
    1. Cover the area that is being cut with a shop rag or a piece of cloth because there is a possibility that metal shards may be dispersed by the gas.
    2. The gas is colorless, odorless and harmless.