Home › BODY › ENGINE HOOD / DOOR › HOOD SUPPORT

HOOD SUPPORT > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE HOOD SUPPORT


B135981
  1. Using a screwdriver with its tip wrapped in protective tape, remove the 2 stop rings and the hood support.

    NOTICE:
    1. Do not touch the rod of the hood support with gloves, to avoid fibers from adhering.
    2. When foreign matter adheres to the rod, it prevents the rod from moving smoothly and reduces its holding power.

    HINT:
    Support the hood by hand while removing the hood support.