Home › BODY › ENGINE HOOD / DOOR › BACK WINDOW SUPPORT

BACK WINDOW SUPPORT > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE BACK DOOR TRIM COVER


B139381
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the back door trim cover.



2. REMOVE BACK WINDOW SUPPORT


B135523
  1. Using a screwdriver with its tip wrapped in protective tape, remove the 2 stop rings and back window support.

    NOTICE:
    1. Do not touch the rod of the back window support with gloves, to avoid fibers from adhering.
    2. When foreign matter adheres to the rod, it prevents the rod from moving smoothly and reduces its holding power.

    HINT:
    Support the back door glass by hand while removing the back window support.