Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > SYSTEM DESCRIPTION

for Preparation Click here



METER GAUGE AND WARNING INDICATOR

Meter/Gauge 
Item
Signal Description
Speedometer
Indicates vehicle speed based on signals received from skid control ECU (CAN).
Tachometer
Indicates engine speed based on signals from ECM (CAN).
Fuel Gauge
Indicates fuel level in accordance with signals received from fuel sender gauge (Direct Line).
Engine Coolant Temperature Gauge
Indicates engine coolant temperature in accordance with signal from ECM (CAN).
Volt Gauge
Indicates vehicle voltage according to voltage from IG terminal (Direct Line).
ODO/TRIP meter
Calculates accumulated total vehicle travel distance and vehicle travel distance since trip meter knob pressed.

Warning/Indicator 
Item
Signal Description
TURN SIGNAL
Receives turn signal from turn signal flasher (Direct Line).
BEAM
Receives beam signal from main body ECU (BEAN).
BRAKE
  1. Receives parking brake switch signal from skid control ECU (CAN).
  2. Receives fluid level warning signal from skid control ECU (CAN).
DOOR
Open door indicator illuminates when receiving signal from main body ECU (BEAN).
RSCA OFF
Receives RSCA OFF signal from center airbag sensor assembly (Direct Line).
AIRBAG
Receives malfunction signal from center airbag sensor assembly (CAN).
D BELT
Receives driver seat belt signal (unfastened) from driver seat belt buckle switch (Direct Line).
TIRE PRESSURE
Receives malfunction signal from tire pressure warning ECU (Direct Line).
MAINT REQD*1
  1. Blinks when about 4500 miles driven since oil change.
  2. Illuminates when about 5000 miles driven since oil change.
OIL PRESSURE
Receives malfunction signal from engine oil pressure switch (Direct Line).
A-TRAC*2
Receives A-TRAC signal from skid control ECU (CAN).
AUTO LSD*3
Receives signals from skid control ECU while AUTO LSD is operating (CAN).
WASHER*4
Receives washer level warning signal from washer level warning switch (Direct Line).
A/T OIL TEMP*5
Warning is displayed when oil temperature is high (CAN).
MIL
Receives malfunction check signal from ECM (Direct Line).
ABS
Receives malfunction signal from skid control ECU (CAN).
CRUISE*6
Receives malfunction signal from ECM (CAN).
TRAC OFF
Receives TRAC control off signal from skid control ECU (CAN).
SLIP
Receives malfunction signal from skid control ECU (CAN).
VSC OFF
Receives VSC control off signal from skid control ECU (CAN).
CRAWL*7
Receives CRAWL signals from driving support switch control ECU (CAN).
CHARGE
Receives malfunction signal from generator assembly (Direct Line).
A/T P*8
Receives signal from transfer indicator switch (neutral position) (Direct Line).
FUEL
Receives fuel empty signals from fuel sender gauge (Direct Line).
4WD*8
Receives signals from 4WD control ECU while 4WD is operating (Direct Line).
CENTER DIFFERENTIAL LOCK*9
Receives signals from transfer indicator switch (center differential) while center differential lock is operating (Direct Line).
REAR DIFFERENTIAL LOCK*10
Receives signals from differential lock switch while rear differential lock is operating (Direct Line).
  1. *1: for U.S.A.
  2. *2: w/ Active Traction Control
  3. *3: for 2WD
  4. *4: for Canada
  5. *5: for Automatic Transmission
  6. *6: w/ Cruise Control
  7. *7: w/ CRAWL
  8. *8: for Automatic Transmission with 4WD
  9. *9: for Manual Transmission
  10. *10: w/ Rear Differential Lock

Buzzer 
Item
Signal Description
Seat Belt Warning
Buzzer is ON: Vehicle speed exceeds 20 km/h (12.4 mph) and seat belt unfastened.
Key Reminder
Buzzer is ON: Ignition switch is off, key is inserted, and driver door open.
Manual Shift Reverse*1
Buzzer is ON: Ignition switch is ON, shift position is reverse.
Brake System Buzzer
Buzzer ON: Receives signal from skid control ECU (CAN).
  1. *1: for Manual Transmission

LED CHECK
  1. Check the indicator/warning light operation according to the condition(s) in the table below.

    Indicator/Warning Light
    Specification
    BRAKE, ABS, SLIP, VSC OFF, CRAWL*1, A-TRAC*2, TIRE PRESSURE, MAINT REQD*3, AUTO LSD*4
    Indicator/Warning light comes on for about 3 seconds after turning the ignition switch to ON.
    AIRBAG
    Warning light comes on for about 6 seconds after turning the ignition switch to ON.
    CHARGE, OIL PRESSURE, MIL, A/T OIL TEMP*5
    Indicator/Warning light comes on after turning the ignition switch to ON and the indicator light turns off after the engine starts.

    1. *1: w/ CRAWL
    2. *2: w/ Active Traction Control
    3. *3: for U.S.A.
    4. *4: for 2WD
    5. *5: for Automatic Transmission