Home › BODY › MIRROR › OUTER REAR VIEW MIRROR

OUTER REAR VIEW MIRROR > INSPECTION

for Preparation Click here



1. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH


    B135566
  1. Check the operation.

    1. Apply battery voltage to the outer rear view mirror and check the operation of the outer rear view mirror.

      Standard:
      Measurement Condition
      Mirror Assembly Operation
      Battery positive (+) - Terminal 3 (MV)
      Battery negative (-) - Terminal 4 (COM)
      Turns upward
      Battery positive (+) - Terminal 4 (COM)
      Battery negative (-) - Terminal 3 (MV)
      Turns downward
      Battery positive (+) - Terminal 5 (MH)
      Battery negative (-) - Terminal 4 (COM)
      Turns left
      Battery positive (+) - Terminal 4 (COM)
      Battery negative (-) - Terminal 5 (MH)
      Turns right

      If the result is not as specified, replace the outer rear view mirror.



2. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH


    B135567
  1. Check the operation.

    1. Apply battery voltage to the outer rear view mirror and check the operation of the outer rear view mirror.

      Standard:
      Measurement Condition
      Mirror Assembly Operation
      Battery positive (+) - Terminal 3 (MV)
      Battery negative (-) - Terminal 4 (COM)
      Turns upward
      Battery positive (+) - Terminal 4 (COM)
      Battery negative (-) - Terminal 3 (MV)
      Turns downward
      Battery positive (+) - Terminal 5 (MH)
      Battery negative (-) - Terminal 4 (COM)
      Turns left
      Battery positive (+) - Terminal 4 (COM)
      Battery negative (-) - Terminal 5 (MH)
      Turns right

      If the result is not as specified, replace the outer rear view mirror.



3. INSPECT OUTER REAR VIEW MIRROR ILLUMINATION LIGHT


B140027
  1. Check the illumination operation.

    1. Connect the positive (+) battery lead to terminal 2 and the negative (-) battery lead to terminal 1, then check that the illumination illuminates.

      Standard:
      Illumination illuminates.

      If the illumination does not illuminate, check the faulty bulb.

  1. Inspect the bulb.

    1. Inspect continuity of the bulb by connecting the tester.

      Standard:
      Continuity.

      If continuity exists, replace the outer rear view mirror.
      If no continuity exists, replace the bulb.