Home › BODY ELECTRICAL › LIGHTING › PERSONAL LIGHT ASSEMBLY (w/o CRAWL)

PERSONAL LIGHT ASSEMBLY (w/o CRAWL) > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 PERSONAL LIGHT LENS


B205289E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the No. 1 personal light lens.



2. REMOVE NO. 2 PERSONAL LIGHT LENS

HINT:
Perform the same procedure as for the RH side.



3. REMOVE PERSONAL LIGHT ASSEMBLY


B205290E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws.

  1. Disconnect the connector, and remove the personal light.



4. REMOVE PERSONAL LIGHT BULB


B205292
  1. Turn the 2 personal light sockets and bulbs, in the direction indicated by the arrows in the illustration, to remove them.

  1. Remove the 2 personal light bulbs from the light socket.