ROOM LIGHT ASSEMBLY (for Rear) > INSPECTION |
| 1. INSPECT REAR ROOM LIGHT ASSEMBLY |
![]() |
Check the resistance.
Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| - | OFF | 10 kΩ or higher |
| CTY - B | DOOR | Below 1 Ω |
| B - E | ON | Below 1 Ω |
Check the light operation.
Connect the positive (+) battery lead to terminal B and the negative (-) battery lead to terminal CTY, then check that the light illuminates when the switch is in the DOOR position.
Connect the positive (+) battery lead to terminal B and the negative (-) battery lead to terminal E, then check that the light illuminates when the switch is in the ON position.