Home › BODY ELECTRICAL › LIGHTING › ROOM LIGHT ASSEMBLY

ROOM LIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE ROOM LIGHT ASSEMBLY


E114441E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the room light lens.



    E114442E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws.



    B138413E01
  1. Disengage the roof wire from the claw of the room light.

  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the room light switch base.

  1. Remove room light bulb No. 1.