Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT DIMMER SWITCH


  1. Check the resistance of the light control switch.



      E127238E03
    1. Measure the resistance according to the value(s) in the table below.
      Text in Illustration 
      *a
      Component without harness connected
      (Headlight Dimmer Switch)

      Standard Resistance:
      Light control switch (w/o DRL OFF function) 
      Tester Connection
      Switch Condition
      Specified Condition
      14 (T) - 16 (EL)
      OFF
      10 kΩ or higher
      13 (H) - 16 (EL)
      OFF
      10 kΩ or higher
      14 (T) - 16 (EL)
      TAIL
      Below 1 Ω
      14 (T) - 16 (EL)
      HEAD
      Below 1 Ω
      13 (H) - 16 (EL)
      HEAD
      Below 1 Ω
      Light control switch (w/ DRL OFF function) 
      Tester Connection
      Switch Condition
      Specified Condition
      14 (T) - 16 (EL)
      OFF
      10 kΩ or higher
      13 (H) - 16 (EL)
      OFF
      10 kΩ or higher
      12 (A) - 16 (EL)
      OFF
      10 kΩ or higher
      12 (A) - 16 (EL)
      DRL
      Below 1 Ω
      14 (T) - 16 (EL)
      TAIL
      Below 1 Ω
      14 (T) - 16 (EL)
      HEAD
      Below 1 Ω
      13 (H) - 16 (EL)
      HEAD
      Below 1 Ω

      If the result is not as specified, replace the headlight dimmer switch.

  1. Check the resistance of the headlight dimmer switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      8 (HF) - 16 (EL)
      FLASH
      Below 1 Ω
      7 (HU) - 16 (EL)
      FLASH
      Below 1 Ω
      16 (EL) - 17 (HL)
      LOW BEAM
      Below 1 Ω
      7 (HU) - 16 (EL)
      HI BEAM
      Below 1 Ω

      If the result is not as specified, replace the headlight dimmer switch.

  1. Check the resistance of the turn signal switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      2 (TB) - 3 (TR)
      Right turn
      Below 1 Ω
      2 (TB) - 3 (TR)
      Neutral
      10 kΩ or higher
      1 (TL) - 2 (TB)
      Neutral
      10 kΩ or higher
      1 (TL) - 2 (TB)
      Left turn
      Below 1 Ω

      If the result is not as specified, replace the headlight dimmer switch.