Home › BODY ELECTRICAL › LIGHTING › STOP LIGHT SWITCH

STOP LIGHT SWITCH > INSPECTION

for Preparation Click here



1. INSPECT STOP LIGHT SWITCH


    B113724E04
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      Switch pin released
      Below 1 Ω
      3 - 4
      Switch pin released
      10 kΩ or higher
      1 - 2
      Switch pin pushed in
      10 kΩ or higher
      3 - 4
      Switch pin pushed in
      Below 1 Ω

      If the result is not as specified, replace the stop light switch.