Home › BODY ELECTRICAL › LIGHTING › TURN SIGNAL FLASHER ASSEMBLY

TURN SIGNAL FLASHER ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT TURN SIGNAL FLASHER CIRCUIT


E068703E05
  1. Check the power source circuit and ground circuit.

    1. Disconnect the turn signal flasher connector.

    2. Measure the voltage and check the results in accordance with the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Condition
      Specified Condition
      1 - Body ground
      Ignition switch off
      0 V
      1 - Body ground
      Ignition switch ON
      11 to 14 V
      4 - Body ground
      Always
      11 to 14 V

      If the result is not as specified, there may be a malfunction on the wire harness side.

    3. Measure the resistance and check the result in accordance with the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      7 - Body ground
      Always
      Below 1 Ω

      If the result is not as specified, there may be a malfunction on the wire harness side.



  1. Check the output operation signal.



      E101506E01
    1. Reconnect the turn signal flasher connector.

    2. Measure the voltage and check the results in accordance with the value(s) in the table below.

      Standard Voltage:

      Tester Connection
      Condition
      Specified Condition
      2 - Body ground
      Hazard warning switch OFF
      Below 1 V
      2 - Body ground
      Hazard warning switch ON
      11 to 14 V (60 to 120 times per minute)
      2 - Body ground
      Ignition switch ON and turn signal switch (right turn) OFF
      Below 1 V
      2 - Body ground
      Ignition switch ON and turn signal switch (right turn) ON
      11 to 14 V (60 to 120 times per minute)
      3 - Body ground
      Hazard warning switch OFF
      Below 1 V
      3 - Body ground
      Hazard warning switch ON
      11 to 14 V (60 to 120 times per minute)
      3 - Body ground
      Ignition switch ON and turn signal switch (left turn) OFF
      Below 1 V
      3 - Body ground
      Ignition switch ON and turn signal switch (left turn) ON
      11 to 14 V (60 to 120 times per minute)
      5 - Body ground
      Ignition switch ON and turn signal switch (left turn) OFF
      11 to 14 V
      5 - Body ground
      Ignition switch ON and turn signal switch (left turn) ON
      Below 1 V
      6 - Body ground
      Ignition switch ON and turn signal switch (right turn) OFF
      11 to 14 V
      6 - Body ground
      Ignition switch ON and turn signal switch (right turn) ON
      Below 1 V
      8 - Body ground
      Hazard warning switch OFF
      11 to 14 V
      8 - Body ground
      Hazard warning switch ON
      Below 1 V