Home › BODY ELECTRICAL › WIPER AND WASHER › FRONT WIPER MOTOR

FRONT WIPER MOTOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE WINDSHIELD WIPER ARM COVER


    E127858E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the 3 front wiper arm cover.



3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH


    E127859
  1. Operate the wiper, then stop the windshield wiper motor in the automatic stop position.

  1. Remove the nut and front wiper arm.



4. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH (CENTER SIDE)

HINT:
Use the same procedure as for the LH side.



5. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



6. REMOVE ROOF ANTENNA POLE SUB-ASSEMBLY


    E148352
  1. Using a 8 mm (5/16 inch) wrench, remove the radio antenna pole sub-assembly by turning it counterclockwise.



7. REMOVE ANTENNA ORNAMENT


    E127861E01
  1. Pull out the antenna ornament vertically.



8. REMOVE FRONT FENDER SIDE PANEL UPPER RH


    B210064
  1. Disengage the 4 clips and remove the front fender side panel upper RH.

  1. Remove the 4 clips from the front fender side panel upper RH.



9. REMOVE FRONT FENDER SIDE PANEL UPPER LH


    B210065
  1. Disengage the 4 clips and remove the front fender side panel upper LH.

  1. Remove the 4 clips from front fender side panel upper LH.



10. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY


    E127863
  1. Disengage the 7 clips and remove the cowl top ventilator louver sub-assembly.



11. REMOVE COWL TOP VENTILATOR LOUVER RH


    E127864
  1. Disengage the clip and remove the hood to cowl top seal.

  1. Remove the 3 clips and the claw, and remove the cowl top ventilator louver RH.



12. REMOVE COWL TOP VENTILATOR LOUVER LH


    E127865
  1. Remove the 5 clips.

  1. Disengage the 7 claws and remove the cowl top ventilator louver LH.



13. REMOVE FRONT WIPER MOTOR AND LINK


    E127866
  1. Remove the 5 bolts.

  1. Slide the wiper link. Disengage the meshing of the rubber pin, then disconnect the connector and remove the front wiper motor and link.



14. REMOVE FRONT WIPER MOTOR


    E127867E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the meshing of the rod at the crank arm pivot of the front wiper motor.



    E127868E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the meshing of the rod at the crank arm pivot of the front wiper motor.



    E127869
  1. Using "Torx" socket wrench T30, remove the 2 bolts and the front wiper motor.