Home › BODY ELECTRICAL › WIPER AND WASHER › REAR WIPER MOTOR

REAR WIPER MOTOR > INSTALLATION

for Preparation Click here



1. INSTALL REAR WIPER MOTOR


    E127890
  1. Install the rear wiper motor with the 3 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the connector.



2. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY


    E058837E10
  1. Scrape any metal powder off the serrated part of the wiper arm with a round file or the equivalent (when reinstalling).

  1. Clean the wiper pivot serrations with a wire brush.

  1. Operate the wiper, then stop the windshield wiper motor in the automatic stop position.



    E129609E01
  1. Install the rear wiper arm in the position shown in the illustration with the nut.

    Torque:
    12 N*m{ 117 kgf*cm , 8 ft.*lbf }

    HINT:
    Using the nut, Tighten the rear wiper arm with the slider on the linear wiper step, 20 mm below the rise-up position in the rotational direction.

  1. Return the slider to the rise-up position.



    E129608
  1. Close the rear wiper arm head cap.



3. INSTALL BACK DOOR SERVICE HOLE COVER


    B135595
  1. Apply butyl tape to the door panel, then install the new back door service hole cover as shown in the illustration.

    HINT:
    1. When installing the service hole cover, pull the links and connectors out through the service hole.
    2. There should be no wrinkles or folds after attaching the service hole cover.
    3. After attaching the service hole cover, check the quality of the seal.



4. INSTALL BACK DOOR TRIM BOARD


    B135554
  1. Engage the 16 clips and install the back door trim board.

  1. Install the 2 screws.



5. INSTALL DOOR TRIM RETAINER CAP


    B135553
  1. Engage the 2 claws and install the door trim retainer cap.



6. INSTALL BACK DOOR TRIM COVER LH

HINT:
Use the same procedure as described for the RH side.



7. INSTALL BACK DOOR TRIM COVER RH


B139382
  1. Engage the 3 claws and back door trim cover.



8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }