Home › BODY ELECTRICAL › WIPER AND WASHER › REAR WIPER MOTOR

REAR WIPER MOTOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE BACK DOOR TRIM COVER RH


B139381
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the back door trim cover.



3. REMOVE BACK DOOR TRIM COVER LH

HINT:
Use the same procedure as described for the RH side.



4. REMOVE DOOR TRIM RETAINER CAP


B135553
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the door trim retainer cap.



5. REMOVE BACK DOOR TRIM BOARD


B135554
  1. Remove the 2 screws.

  1. Disengage the 16 clips and remove the back door trim board.



6. REMOVE BACK DOOR SERVICE HOLE COVER


B135544
  1. Remove the back door service hole cover.

    NOTICE:
    Remove any tape remaining on the door side.



7. REMOVE REAR WIPER ARM AND BLADE ASSEMBLY


    E127888
  1. Open the rear wiper arm head cap.



    E127889
  1. Remove the nut and the rear wiper arm and blade.



8. REMOVE REAR WIPER MOTOR


    E127890
  1. Disconnect the connector.

  1. Remove 3 bolts and the rear wiper motor.