Home › BODY ELECTRICAL › WIPER AND WASHER › WASHER LEVEL WARNING SWITCH

WASHER LEVEL WARNING SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL LEVEL WARNING SWITCH ASSEMBLY
  1. Install the washer level warning switch assembly.

  1. Connect the connector.



2. INSTALL WINDSHIELD WASHER JAR ASSEMBLY
  1. Install the windshield washer jar with the 3 bolts.

    Torque:
    3.5 N*m{ 36 kgf*cm , 31 in.*lbf }

  1. Connect the connector.



3. INSTALL WASHER INLET SUB-ASSEMBLY
  1. Engage the claw and install the washer inlet.

  1. Install the washer jar inlet filter.



4. INSTALL FRONT FENDER LINER RH
  1. Install the front fender liner RH with the clip and the 4 grommets.

  1. Install the 2 bolts and the 6 screws.



5. FILL UP WASHER JAR AND PUMP ASSEMBLY WITH WASHER FLUID
  1. Fill the washer jar with washer fluid.