Home › BODY ELECTRICAL › WIPER AND WASHER › WASHER MOTOR

WASHER MOTOR > REMOVAL

for Preparation Click here



1. SEPARATE FRONT FENDER LINER RH
  1. Remove the 2 bolts and the 6 screws.

  1. Remove the clip and the 4 grommets and then separate the front fender liner RH.



2. DRAIN WASHER FLUID
  1. Disconnect the 2 washer hoses from the windshield washer motor and pump, and drain the washer fluid.



3. REMOVE WASHER INLET SUB-ASSEMBLY


B242135
  1. Remove the washer jar inlet filter.

  1. Disengage the claw and then remove the washer inlet.



4. REMOVE WINDSHIELD WASHER JAR ASSEMBLY


B242136
  1. Disconnect the connector.

  1. Remove the 3 bolts and the windshield washer jar assembly.



5. REMOVE FRONT WASHER MOTOR AND PUMP ASSEMBLY


B242133
  1. Disconnect the connector.

  1. Pull the washer motor and pump out of the packing of the washer jar.



6. REMOVE REAR WASHER MOTOR AND PUMP ASSEMBLY (w/ Rear Wiper)


B242134
  1. Disconnect the connector.

  1. Pull the washer motor and pump out of the packing of the washer jar.