Home › BODY ELECTRICAL › WIPER AND WASHER › WASHER LEVEL WARNING SWITCH

WASHER LEVEL WARNING SWITCH > REMOVAL

for Preparation Click here



1. REMOVE FRONT FENDER LINER RH
  1. Remove the 2 bolts and the 6 screws.

  1. Remove the clip and the 4 grommets and then separate the front fender liner RH.



2. DRAIN WASHER FLUID
  1. Disconnect the 2 washer hoses from the windshield washer motor and pump, and drain the washer fluid.



3. REMOVE WASHER INLET SUB-ASSEMBLY


B242135
  1. Remove the washer jar inlet filter.

  1. Disengage the claw and then remove the washer inlet.



4. REMOVE WINDSHIELD WASHER JAR ASSEMBLY


B242136
  1. Disconnect the connector.

  1. Remove the 3 bolts and the windshield washer jar assembly.



5. REMOVE LEVEL WARNING SWITCH ASSEMBLY


B242138
  1. Disconnect the connector.

  1. Remove the washer level warning switch assembly.