Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


*: Use a Techstream.


1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.DTCS AND FREEZE FRAME DATA CHECK AND CLEARANCE*

        NEXT


        4.PROBLEM SYMPTOM CONFIRMATION
          Result 
          Result
          Proceed to
          Symptom does not occur
          A
          Symptom occurs
          B


        B.
        SYMPTOM SIMULATION
        A


        5.CHECK CAN COMMUNICATION SYSTEM*
        1. Check for the output DTCs relating to the CAN communication system.

          HINT:
          The ECU of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, be sure to check that there is no trouble in the CAN communication system.

          Result 
          Result
          Proceed to
          CAN communication system DTC not output
          A
          CAN communication system DTC output
          B



        B.
        CAN COMMUNICATION SYSTEM
        A


        6.DTC CHECK*

          HINT:
          Click here.

          Result 
          Result
          Proceed to
          DTC output
          A
          DTC not output
          B


        B.
        PROBLEM SYMPTOMS TABLE
        A


        7.DTC CHART

          HINT:
          Click here.


        NEXT


        8.CIRCUIT INSPECTION

          HINT:
          When 2 or more DTCs are detected, perform circuit inspections one by one until the problem is identified.


        NEXT


        9.PROBLEM IDENTIFICATION

          NEXT


          10.REPAIR OR REPLACEMENT

            NEXT


            11.CONFIRMATION TEST*

              NEXT

              END