VEHICLE STABILITY CONTROL SYSTEM > CALIBRATION |
| DESCRIPTION |
After replacing the VSC relevant components or performing "Front wheel alignment adjustment", clearing and reading the sensor calibration data are necessary.
Follow the chart to perform calibration.
| Replacing Parts | Necessary Operations |
| Master Cylinder Solenoid (Skid Control ECU) | Yaw rate and deceleration sensor zero point calibration. |
| Yaw Rate Sensor |
|
| Front Wheel Alignment |
|
| CLEAR ZERO POINT CALIBRATION (for Using a Techstream) |
Turn the ignition switch off.
Check that the steering wheel is in the straight-ahead position.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Select the following menus: Chassis / ABS/VSC/TRAC / Utility / Reset Memory
| PERFORM ZERO POINT CALIBRATION OF YAW RATE AND DECELERATION SENSOR (for Using a Techstream) |
Procedures for test mode.
Turn the ignition switch off.
Check that the steering wheel is in the straight-ahead position.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Switch the ECU to test mode using the Techstream.
Select the following menus: Chassis / ABS/VSC/TRAC / Utility / Test Mode
Keep the vehicle stationary on a level surface for 5 seconds or more.
Check that the SLIP indicator light blinks as shown in the illustration.
| CLEAR ZERO POINT CALIBRATION (for Using SST Check Wire) |
Turn the ignition switch to ON.
![]() |
Using SST, connect and disconnect terminals 12 (TS) and 4 (CG) of the DLC3 4 times or more within 8 seconds.
| *a | Front view of DLC3 |
Check that the warning light blinks in a normal system indication pattern.
| PERFORM ZERO POINT CALIBRATION OF YAW RATE AND DECELERATION SENSOR (for Using SST Check Wire) |
Procedures for test mode:
Turn the ignition switch off.
Check that the steering wheel is in the straight-ahead position.
![]() |
Using SST, connect terminals 12 (TS) and 4 (CG) of the DLC3.
| *a | Front view of DLC3 |
Turn the ignition switch to ON.
Keep the vehicle stationary on a level surface for 5 seconds or more.
Check that the SLIP indicator light blinks as shown in the illustration.