Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > CHECK FOR INTERMITTENT PROBLEMS

for Preparation Click here



DESCRIPTION

HINT:
A momentary interruption (open circuit) in the connectors and/or wire harness between the sensors and ECUs can be detected through the ECU data monitor function of the Techstream.

  1. Turn the ignition switch off and connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON. Follow the on-screen directions on the Techstream to display the Data List and select areas which should be monitored for momentary interruptions.

    HINT:
    A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).


    Tester Display
    Measurement Item / Range
    Normal Condition
    Diagnostic Note
    FR Speed Open
    FR speed sensor open detection / OPN_DET or NORMAL
    OPN_DET : Momentary interruption
    NORMAL : Normal
    -
    FL Speed Open
    FL speed sensor open detection / OPN_DET or NORMAL
    OPN_DET : Momentary interruption
    NORMAL : Normal
    -
    RR Speed Open
    RR speed sensor open detection / OPN_DET or NORMAL
    OPN_DET : Momentary interruption
    NORMAL : Normal
    -
    RL Speed Open
    RL speed sensor open detection / OPN_DET or NORMAL
    OPN_DET : Momentary interruption
    NORMAL : Normal
    -
    EFI Open
    EFI communication open detection / OPN_DET or NORMAL
    OPN_DET : Momentary interruption
    NORMAL : Normal
    -
    Yaw Rate Open
    Yaw rate sensor open detection / OPN_DET or NORMAL
    OPN_DET : Momentary interruption
    NORMAL : Normal
    -
    Deceleration Open
    Deceleration sensor open detection / OPN_DET or NORMAL
    OPN_DET : Momentary interruption
    NORMAL : Normal
    -
    Steering Open
    Steering angle sensor open detection / OPN_DET or NORMAL
    OPN_DET : Momentary interruption
    NORMAL : Normal
    -
    Accumulator Open
    Accumulator pressure sensor open detection / OPN_DET or NORMAL
    OPN_DET : Momentary interruption
    NORMAL : Normal
    -

    HINT:
    1. If the Techstream status remains open, check the continuity between the ECU and the sensors, or between ECUs.
    2. The OPEN display on the Techstream remains on for 1 second after the harness signal changes from momentary interruption (open circuit) to normal condition.

  3. While observing the screen, gently jiggle the connector or wire harness between the ECU and sensors, or between ECUs.

    OK:
    OPEN-screen display does not change.