Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > FREEZE FRAME DATA

for Preparation Click here



HINT:
  1. Whenever a DTC is detected or the ABS operates, the skid control ECU stores the current vehicle (sensor) state as freeze frame data.
  2. The skid control ECU stores the number of times (maximum: 31) the ignition switch has been turned from OFF to ON since the last time the ABS was activated. However, if the vehicle was stopped or at low speed (4.3 mph (7 km/h) or less), or if a DTC is detected, the skid control ECU will not count the number after that.
  3. Freeze frame data at the time the ABS operates: The skid control ECU stores and updates the data whenever the ABS system operates. When the ECU stores data at the time a DTC is detected, the data stored when the ABS operated is erased.
  4. Freeze frame data at the time a DTC is detected: When the skid control ECU stores data at the time a DTC is detected, no updates will be performed until the data is cleared.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the Techstream on.

  4. Check the freeze frame data by following the prompts on the Techstream display.


ABS/VSC/TRAC 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Elapsed Time after Freeze Trigger
Elapsed time after freeze trigger/ Min.: 0 msec, Max.: 500 msec
-
-
Number of IG ON
Number of times ignition switch turned to ON after storing freeze frame data/ 0 to 31
-
-
Buzzer
Skid control buzzer/ ON or OFF
ON: Buzzer on
OFF: Buzzer off
-
Stop Light SW
Stop light switch/ ON or OFF
ON: Brake pedal depressed
OFF: Brake pedal released
-
Parking Brake SW
Parking brake switch/ ON or OFF
ON: Parking brake applied
OFF: Parking brake released
-
Reservoir Warning SW
Brake fluid level warning switch/ ON or OFF
OFF
-
Gear Position
Gear position information/ P/N, R, 1st-8th, Fail or Not R
Actual gear position
-
Shift Lever Position
Shift lever position information/ P/N, R, D/M, 1st-6th/B or Fail
Actual shift lever position
-
Operated System
Operated system status/ ABS, VSC, TRAC, BA, HAB, Fail, Sys or Non
-
ABS: ABS is activated.
VSC: VSC is activated.
TRAC: TRAC is activated.
BA: BA is activated.
HAB: HAB is activated.
Fail: Fail safe mode is activated.
Sys: System prohibit is activated.
Non: No operation is activated.
Master Cylinder Sensor
Master cylinder pressure sensor reading/ Min.: 0.00 V, Max.: 5.00 V
When brake pedal released: 0.3 to 0.9 V
The value increases when the brake pedal is depressed.
M/C Sensor Grade
Master cylinder pressure sensor change/ Min.: -30 MPa/s, Max.: 225 MPa/s
When brake pedal released or pedal held at constant position: 0 MPa/s
Changes in proportion with the pedal movement speed when the brake pedal is being operated.
Yaw Rate Sensor
Yaw rate and deceleration sensor/ Min.: -128°/s, Max.: 127°/s
Vehicle stopped: 0°/s
Turning right: -128 to 0°/s
Turning left: 0 to 127°/s
-
Lateral G
Lateral G/ Min.: -25.10 m/s2, Max.: 24.90 m/s2
-
Changes in proportion with the pedal movement speed when the brake pedal is being operated.
Forward and Rearward G
Forward and backward G/ Min.: - 25.10 m/s2, Max.: 24.90 m/s2
-
Changes in proportion with acceleration during acceleration/deceleration.
FR Wheel Speed
Front wheel speed sensor RH reading/ Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph)
No large fluctuations when driving at a constant speed.
FL Wheel Speed
Front wheel speed sensor LH reading/ Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph)
No large fluctuations when driving at a constant speed.
RR Wheel Speed
Rear wheel speed sensor RH reading/ Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph)
No large fluctuations when driving at a constant speed.
RL Wheel Speed
Rear wheel speed sensor LH reading/ Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph)
No large fluctuations when driving at a constant speed.
Vehicle Speed
Maximum wheel speed sensor reading/ Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph)
No large fluctuations when driving at a constant speed.
Vehicle Speed Grade
Vehicle acceleration/ Min.: -25.10 m/s2, Max.: 24.90 m/s2
Vehicle stopped: 0 m/s2
Changes in proportion with the vehicle acceleration/deceleration during driving.
FR Wheel Direction
Front wheel RH direction signal/ Forward or Back
Forward: Forward
Back: Backward
-
FL Wheel Direction
Front wheel LH direction signal/ Forward or Back
Forward: Forward
Back: Backward
-
RR Wheel Direction
Rear wheel RH direction signal/ Forward or Back
Forward: Forward
Back: Backward
-
RL Wheel Direction
Rear wheel LH direction signal/ Forward or Back
Forward: Forward
Back: Backward
-
Real Engine Torque
Actual engine torque/ Min.: -1024.0 Nm, Max.: 1023.0 Nm
-
-
Accelerator Opening Angle %
Throttle valve opening amount/ Min.: 0.0%, Max.: 128.0%
When accelerator pedal released: 0%
Changes in proportion with the movement of the pedal during accelerator pedal operation.
Steering Angle Sensor
Steering angle sensor/ Min.: - 3276.8°, Max.: 3276.7°
Left turn: Increase
Right turn: Decrease
-
TRAC/VSC Off Mode
TRAC/VSC off mode/ Normal, TRC OFF or VSC OFF
Normal: Normal mode
TRC OFF: TRAC off mode
VSC OFF: VSC off mode
-