CLUTCH START CANCEL SWITCH > INSPECTION |
| 1. INSPECT CLUTCH START CANCEL SWITCH ASSEMBLY |
![]() |
Using an ohmmeter, check that there is resistance between terminals 2 and 4.
![]() |
Connect the positive (+) lead from the battery to terminal 3 and connect the negative (-) lead to terminal 1.
Using an ohmmeter, check that there is resistance between terminals 2 and 4.
![]() |
Check that the indicator light comes on and there is resistance between terminals 2 and 4 when the switch is pressed.
![]() |
Using an ohmmeter, check that there is resistance between terminals 2 and 4 when the battery lead is disconnected.