Home › BODY ELECTRICAL › DOOR LOCK › UNLOCK WARNING SWITCH

UNLOCK WARNING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT UNLOCK WARNING SWITCH


B135516E01
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      Pin released
      10 kΩ or higher
      1 - 2
      Pin pushed in
      Below 1 Ω

      If the result is not as specified, replace the unlock warning switch.