ENGINE IMMOBILISER SYSTEM > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Connect a Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Immobiliser / Data List.
According to the display on the tester, read the "Data List".
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| D Door Courtesy SW | Driver door courtesy light switch signal / ON or OFF | ON: Driver door open OFF: Driver door closed | - |
| Key SW | Unlock warning switch signal/ON or OFF | ON: Key is in ignition key cylinder OFF: No key is in ignition key cylinder | - |
| IG SW | Ignition switch signal/ON or OFF | ON: Ignition switch ON or START OFF: Ignition switch ACC or OFF | - |
| Immobiliser | Immobiliser system status/SET or UNSET | UNSET: Ignition switch ON SET: Without key | - |
| Response | Transponder chip data/NG or OK | NG: Data error OK: Data OK | - |
| Frame Error | Transponder chip data/NG or OK | NG: Data error OK: Data OK | - |
| Different Serial Number | Transponder chip data/NG or OK | NG: Data error OK: Data OK | - |
| Different Encrypt Code | Transponder chip data/NG or OK | NG: Data error OK: Data OK | - |
| Abnormal Status | Transponder chip data/NG or OK | NG: Data error OK: Data OK | - |
| Bcc Malfunction | Transponder chip data/NG or OK | NG: Incorrect data being sent OK: Correct data being sent | - |
| Sub Key | Sub key code signal/NOMATCH or MATCH | NOMATCH: Non-matching sub key code is sent MATCH: Sub key code is sent | - |
| Master Key | Master key code signal/NOMATCH or MATCH | NOMATCH: Non-matching master key code is sent MATCH: Master key code is sent | - |
| Transponder S-Code | Number of registered sub key/min. 0, max. 15 | Number of registered sub keys | - |
| Transponder M-Code | Number of registered master key/min. 0, max. 15 | Number of registered master keys | - |
| Reg Code Space Full | Memory space for key codes registration/NOT FULL or FULL | NOT FULL: More key code registration possible FULL: No more key code registration possible | - |
| +B | Power source/BRAKE or NORMAL | BRAKE: Power source open NORMAL: Power source normal | - |
| Antenna Coil Status | Transponder key amplifier coil condition/NORMAL or FAIL | NORMAL: Antenna coil is normal FAIL: Antenna coil is malfunctioning | - |
| EEPROM Status | EEPROM status/OK or NG | OK: EEPROM is normal NG: EEPROM is malfunctioning | - |
| E/G Start Permission | Permit (Start) signal/OK or NG | NG: No permission for engine start OK: Engine start permission | - |
| Immobi ECU Comm SpD | Immobiliser ECU Communication Speed status/Unknown, No Response, 50bps or 200bps | Unknown: ECU not connected No Response: ECU connected but does not respond 50bps: Low speed 200bps: High speed | - |
| The Number of DTCs | Number of trouble codes/Min.: 0 or Max.: 255 | Number of DTCs will be displayed | - |
| PERFORM ACTIVE TEST |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Immobiliser / Active Test.
According to the display on the tester, perform the "Active Test".
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Security Indicator | Security indicator light | ON/OFF | - |