Home › BODY ELECTRICAL › DOOR LOCK › DOOR CONTROL SWITCH (for Driver Side)

DOOR CONTROL SWITCH (for Driver Side) > INSPECTION

for Preparation Click here



1. INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY


    E221659E01
  1. Check the resistance of the door control switch.
    Text in Illustration 
    *a
    Component without harness connected
    (Power Window Regulator Master Switch Assembly)
    *b
    LOCK
    *c
    UNLOCK

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 (L1) - 7 (E)
      Locked
      Below 1 Ω
      OFF
      10 kΩ or higher
      9 (UL1) - 7 (E)
      Unlocked
      Below 1 Ω
      OFF
      10 kΩ or higher

      If the result is not as specified, replace the power window regulator master switch.