Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using a Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Main Body / Data List /

  5. According to the display on the Techstream, read the "Data List".

    Main Body ECU 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Luggage Courtesy SW
    Generator L terminal signal / ON or OFF
    ON: Either back door or back window is open
    OFF: Both back door and back window are closed
    -
    D Door Courtesy SW
    Driver door courtesy switch signal / ON or OFF
    ON :Driver door is open
    OFF: Driver door is closed
    -
    P Door Courtesy SW
    Front passenger door courtesy switch signal / ON or OFF
    ON: Front passenger door is open
    OFF: Front passenger door is closed
    -
    Rear Door Courtesy SW
    Rear door courtesy switch signal / ON or OFF
    ON: Either right or left door open
    OFF: Both the right and left rear doors are closed
    -
    Alternator L Terminal
    Back door and back window courtesy switch signal / ON or OFF
    ON: Engine start Charge warning light is OFF
    OFF: Engine start Charge warning light is ON
    -
    Dimmer SW
    Dimmer switch signal / ON or OFF
    ON: Dimmer switch is ON (High Beam) or High flasher switch is ON
    OFF: Dimmer switch is OFF (Low Beam) and High flasher switch is OFF
    -
    Passing Light SW
    High flasher switch signal / ON or OFF
    ON: High flasher switch is ON
    OFF: High flasher switch is OFF
    -
    Head Light SW (Head)
    Headlight switch signal / ON or OFF
    ON: Light control switch is in HEAD position
    OFF: Light control switch is not in HEAD position
    -
    Head Light SW (Tail)
    Taillight switch signal / ON or OFF
    ON: Light control switch is in TAIL or HEAD position
    OFF: Light control switch is not in TAIL and HEAD position
    -
    Daytime Running Light Switch*1
    DRL switch signal / ON or OFF
    ON: Light control switch is in DRL position
    OFF: Light control switch is not in DRL position
    -

    1. *1: w/ DRL OFF function


ACTIVE TEST

HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Main Body / Active Test /

  5. According to the display on the Techstream, perform the "Active Test".

    Main Body ECU 
    Tester Display
    Test Part
    Control Range
    Normal Condition
    Hazard
    Turn signal flasher
    OFF/ON
    -
    Headlight Relay
    Headlight Relay
    OFF/ON
    -
    Head Light Hi
    Headlight (High)
    OFF/ON
    -
    Taillight Relay
    Taillight Relay
    OFF/ON
    -
    Relay of DRL
    DRL relay
    OFF/ON
    -
    Illuminated Entry System
    Transponder key amplifier (Ignition key cylinder light)
    Room light and rear room light (Room lights switch is in DOOR position and all doors are closed)
    OFF/ON
    -
    Open Door Warning Light
    Open door warning light
    OFF/ON
    -
    Doom Relay Cut
    DOME relay
    OFF/ON
    -