Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CLUTCH SWITCH

CLUTCH SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL CLUTCH SWITCH ASSEMBLY


    E129558E01
  1. Fully loosen the lock nut of the clutch switch assembly.

  1. Adjust the clutch switch until the threaded portion comes into contact with the cushion. Tighten the lock nut and ensure that the threaded portion is in contact with the cushion.

    Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }

  1. Connect the connector.



2. INSTALL MAIN BODY ECU (DRIVER SIDE J/B)


E129556
  1. Install the main body ECU with the 2 nuts.

    Torque:
    8.4 N*m{ 86 kgf*cm , 74 in.*lbf }



3. INSTALL INSTRUMENT PANEL SIDE BRACKET


E129555
  1. Install the instrument panel side bracket with the bolt.

    Torque:
    8.4 N*m{ 86 kgf*cm , 74 in.*lbf }



4. INSTALL LOWER INSTRUMENT PANEL LH


    B133864
  1. Install the lower instrument panel with the 4 <F> bolts.



5. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B133860
  1. Engage the 5 clips and claw and install the lower instrument panel finish panel.

  1. Connect the connector.

  1. Install the 2 <F> bolts.



6. INSTALL INSTRUMENT PANEL FINISH PLATE


E149563E01
  1. Install the instrument panel finish plate.



7. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B133859
  1. Engage the 3 claws and install the hood lock control lever.



8. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


    B133853
  1. Disengage the 4 clips and 2 claws and remove the instrument panel register.

    NOTICE:
    1. To avoid breakage of the register, remove the instrument panel register with the shut damper of the register open.
    2. Pull the instrument panel register up diagonally to remove it.



9. INSTALL COWL SIDE TRIM BOARD LH


E129563
  1. Engage the 2 claws and install the cowl side trim board.

  1. Install the clip.



10. INSTALL FOOTREST CLIP


B130588

HINT:
Use the same procedure for both sides.

  1. Engage the 2 claws and install the footrest clip.



11. INSTALL FRONT FLOOR FOOTREST


    B130589
  1. Engage the 2 studs and install the front floor footrest.



12. INSTALL FRONT DOOR SCUFF PLATE LH


E129562
  1. Engage the 14 claws and install the door scuff plate.



13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }