Home › ENGINE › 1GR-FE CHARGING › GENERATOR

GENERATOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL


3. REMOVE BATTERY HOLD DOWN CLAMP


    A226647
  1. Loosen the 2 nuts and remove the battery hold down clamp.



4. REMOVE BATTERY


5. REMOVE BATTERY TRAY


6. REMOVE V-BANK COVER


    A229925E02
  1. Raise the front of the V-bank cover to disengage the 2 pins.
    Text in Illustration 
    *1
    Pin
    *2
    Hook
    *3
    No. 1 V-bank Cover Bracket

  1. Disengage the 2 hooks and remove the V-bank cover from the No. 1 V-bank cover bracket.



7. REMOVE FAN AND GENERATOR V BELT


    A217571
  1. While turning the V-ribbed belt tensioner assembly counterclockwise, align the service hole for the V-ribbed belt tensioner assembly and the V-ribbed belt tensioner assembly fixing position, and then insert a bar of φ 6 mm (0.236 in.) into the service hole to fix the V-ribbed belt tensioner assembly in place.

    HINT:
    The pulley bolt for the V-ribbed belt tensioner assembly has a left-hand thread.

  1. Remove the fan and generator V belt.



8. REMOVE WIRING HARNESS CLAMP BRACKET


    A226648
  1. Disconnect the clamp.

  1. Remove the bolt and wire harness clamp bracket.



9. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR


    A171090
  1. Remove the 3 bolts and No. 2 exhaust manifold heat insulator from the exhaust manifold sub-assembly LH.



10. REMOVE FRONT FENDER APRON SEAL LH


    A223333
  1. Remove the 5 clips and front fender apron seal LH from the front fender apron sub-assembly LH.



11. REMOVE GENERATOR ASSEMBLY


    A222881
  1. Open the terminal cap.

  1. Remove the nut and disconnect the wire harness from terminal B.

  1. Disconnect the generator connector from the generator assembly.



    A222884
  1. Remove the 2 bolts and disconnect the wire harness.



    A222882
  1. Disconnect the wire harness clamp.

  1. Remove the bolt and disconnect the generator bracket from the cylinder block.



    A222883
  1. Remove the 2 bolts and generator assembly.



    A222885
  1. Remove the bolt and generator bracket.