Home › BODY ELECTRICAL › WIPER AND WASHER › WASHER LEVEL WARNING SWITCH

WASHER LEVEL WARNING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT LEVEL WARNING SWITCH ASSEMBLY

HINT:
The following check should be performed with the windshield washer motor and pump installed to the washer jar.

  1. Fill the washer jar with washer fluid.



    B242141E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (S) - 2 (E)
    Fluid volume is more than 700 to 900 ml
    10 kΩ or higher
    1 (S) - 2 (E)
    Fluid volume is less than 700 to 900 ml
    Below 1 Ω

    If the result is not as specified, replace the level warning switch assembly.
     
    *1
    Component without harness connected:
    (Level Warning Switch Assembly)