Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING ECU

TIRE PRESSURE WARNING ECU > REMOVAL

for Preparation Click here



1. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


    B133854E01
  1. Disengage the claw and separate the glove compartment door stoppers from the glove compartment door.

  1. Slightly flex the upper part of the glove compartment door assembly to release the 2 stoppers and open the glove compartment door until it becomes horizontal.



    B133855
  1. Pull the glove compartment door assembly toward the rear of the vehicle to release the 3 hinges and remove the glove compartment door assembly.



2. REMOVE INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY RH


    B133857
  1. Remove screw <A>.

  1. Disengage the 2 clips and claw and remove the instrument panel lower finish panel.

  1. Separate the connectors from the instrument panel lower finish panel.



3. REMOVE TIRE PRESSURE WARNING ECU
  1. Disconnect the tire pressure warning ECU connector.



    C168862
  1. Remove the nut and tire pressure warning ECU.