Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Multi-media Interface ECU and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal of an external device to the multi-media interface ECU through this circuit.

WIRING DIAGRAM


E193011E40


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - NO. 1 STEREO JACK ADAPTER)
  1. Disconnect the E88 multi-media interface ECU connector.

  1. Disconnect the E87 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E87-3 (UDO+) - E88-3 (UDI+)
    Always
    Below 1 Ω
    E87-2 (UDO-) - E88-2 (UDI-)
    Always
    Below 1 Ω
    E87-3 (UDO+) - Body ground
    Always
    10 kΩ or higher
    E87-2 (UDO-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)