Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CLUTCH SWITCH

CLUTCH SWITCH > INSPECTION

for Preparation Click here



1. INSPECT CLUTCH SWITCH


    E129559E01
  1. Remove the clutch switch.

  1. Measure the resistance and check that the results are in accordance with the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Switch pin released (Clutch pedal depressed)
    10 kΩ or higher
    1 - 2
    Switch pin pushed in (Clutch pedal released)
    Below 1Ω

    If the result is not as specified, replace the clutch switch.