Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The No. 1 stereo jack adapter assembly sends sound signals from an external device to the radio receiver assembly through this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier assembly or radio receiver assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, radio receiver assembly or speakers.

WIRING DIAGRAM


E219860E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the E87 No. 1 stereo jack adapter assembly and E43 radio receiver assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E87-8 (AUXO) - E43-19 (AUXI)
    Always
    Below 1 Ω
    E87-7 (ASGN) - E43-16 (ASGN)
    Always
    Below 1 Ω
    E87-5 (ARO) - E43-15 (ARI)
    Always
    Below 1 Ω
    E87-6 (ALO) - E43-17 (ALI)
    Always
    Below 1 Ω
    E87-9 (AGND) - E43-18 (AGND)
    Always
    Below 1 Ω
    E87-8 (AUXO) - Body ground
    Always
    10 kΩ or higher
    E87-7 (ASGN) - Body ground
    Always
    10 kΩ or higher
    E87-5 (ARO) - Body ground
    Always
    10 kΩ or higher
    E87-6 (ALO) - Body ground
    Always
    10 kΩ or higher
    E87-9 (AGND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)